Loading/Transport - Bomag BW 100 AD-4 Operating Instructions Manual

5.19 Loading/transport

Loading with loading ramp
Danger
!
Danger of accident! Life hazard!
Use only stable loading ramps of sufficient
load bearing capacity. The ramp inclination
must be less than the gradability of the ma-
chine.
Make sure that persons are not endangered by
the machine tipping or sliding off.
During demonstration and when loading the
machine do not remain in the danger zone of
the machine.
After driving the machine onto the transport
vehicle attach the articulation lock .
Caution
!
Always empty the chip spreader
port.
Drive the machine carefully on the transport
l
vehicle.
Fig. 110
After driving the machine onto the transport
l
vehicle swing the articulation lock (Fig. 110)
out of its receptacle and fasten it with the bolt
to the eye. Secure the bolt with the cotter pin.
1 Optional equipment
BW 100/120/125 AD-4/AC-4
Fig. 111
Fold down the foldable ROPS
l
Loosen the eye bolts (Fig. 111) and adjust the
clamping plates vertically.
Fold the foldable ROPS back.
l
Loading by crane
!
1
before trans-
Danger of accident! Life hazard!
Engage the articulation lock.
Always use shackles on the lifting points for
loading the machine.
Check all lifting points for damage before lift-
ing the machine. Do not use a damaged or in
any other way impaired lifting and points.
Lifting tackle must only be attached to loads
by expert personnel (qualified person).
Lift the machine only with suitable lifting gear.
Use only safe lifting gear of sufficient load
bearing capacity Minimum lifting capacity of
lifting gear: see operating weight in chapter
"Technical Data".
Do not lift or lower the machine jerkily.
The tension must always be effective in verti-
cal direction.
The machine must not swing about when be-
ing lifted.
Do not step or stand under suspended loads.
2 Optional equipment
BOMAG
Danger
Operation
2
for transport.
67