Attaching The Brackets To The Chassis - Cisco Physical Access 1125 Appliance User Manual

Rack Mounting the Cisco PAM 1125 Appliance

Attaching the Brackets to the Chassis

Before you begin, check the #10-32 x ½-inch screws that are included in the Fastener Pack to see if they
are the correct size for your rack. If not, obtain the correct screws to use in the procedure where "rack
screws" are required.
To install the Cisco PAM appliance in a front-mount position on a two-post rack system, perform the
following procedure:
Remove the chassis handles by removing two screws (see
Step 1
Then, replace the screws to keep the bezel attached to the appliance.
Figure 3-8
Place a mounting bracket (see item 1 in
Step 2
front-mount position.
Align the holes (see item 2 in
Step 3
Figure 3-9 on page
Slide the bracket toward the front of the chassis, until the forward-most hole on the bracket is aligned
Step 4
with the second hole on the chassis (if you attempt to use the first hole on the chassis, the holes will not
align properly with the bracket).
Attach the bracket to the chassis using hex head screws (see item 4 in
Step 5
In the same manner, attach a bracket to the other side of the chassis.
Step 6
Cisco Physical Access 1125 Appliance User Guide
3-10
Removing a Handle from the Chassis
Figure 3-9 on page
Figure 3-9 on page
3-11) on the chassis and place the bracket against the chassis.
Chapter 3 Rack Mounting the Cisco PAM 1125 Appliance
Figure 3-8 on page
3-11) along one side of the chassis in the
3-11) in the bracket with the tabs (see item 3 in
Figure 3-9 on page
3-10) from each handle.
3-11).
OL-20929-01