Mounting The 1125 Appliance In A Four-Post Rack - Cisco Physical Access 1125 Appliance User Manual

Rack Mounting the Cisco PAM 1125 Appliance
Figure 3-12

Mounting the 1125 Appliance in a Four-Post Rack

When the appliance is installed in a rack and is fully extended on its slide rail, it is possible for the
Warning
rack to become unstable and tip over, which could cause serious injury. To eliminate the risk of rack
instability from extending the rail or in the event of an earthquake, you should affix the rack to the
floor.
The four-post slide rail kit consist of individual left and right slide rails.
the features of the four-post slide rail.
This section contains the following topics:
•
•
•
Note Each rail consists of three pieces that slide to extend the rail to its full length. To access the features of
the innermost piece, such as the release levers (see
piece and pull it firmly out of the piece that contains it.
Cisco Physical Access 1125 Appliance User Guide
3-14
Front-Mounting the Chassis in the Rack
C is
c o
P h
y s
ic a
l A
Setting the Multi-Pin Adapters for Rack Type, page 3-15
Installing the Slide Rails into a Rack with Square Holes, page 3-16
Installing the 1125 Appliance into the Slide Rails, page 3-19
Chapter 3
c c
e s
s M
a n
a g
e r
Figure
Rack Mounting the Cisco PAM 1125 Appliance
Figure 3-13
3-13), you must grasp the end of the innermost
shows the some of
OL-20929-01