Table of Contents
Advertisement
Do not use Planar Ethernet 1 for PXE/DHCP booting or installation. See "Hardware and firmware
requirements" on page 1 for information.
Start Options; then, set Planar Ethernet PXE/DHCP to one of the following
e.
Select
settings:
Disabled
•
Planar Ethernet 2.
•
must also set
f.
Press Esc to exit the
Save Settings
g.
Select
h.
Press Enter to confirm.
Exit Setup
i.
Select
j.
Make sure that
Updating the integrated systems management processor
firmware
Complete the following procedure to update the Intel
management processor (ISMP) firmware. No configuration is required for the Intel
SBXL52 ISMP to enable SOL.
Attention: Do not change the SBCE media tray owner by pressing the button on the front of the blade server
or through the SBCE management-module Web interface while the ISMP firmware update is in progress. This
will interrupt the update procedure and might damage the Intel
Complete the following steps to update the Intel
1.
Get the latest version of the Intel
Corporation Support Representative
2.
Update the blade server ISMP firmware, following the instructions that come with the update file that you
downloaded. To update the blade server ISMP firmware click
the SBCE
management-module Web interface or use an update diskette.
Planar Ethernet PXE/DHCP
If you set
Run PXE only on selected Planar NIC
Start Options
section of the Configuration/Setup Utility program.
; then, press Enter.
; then, press Enter.
Yes, exit the Setup Utility
®
Server Compute Blade SBXL52 ISMP firmware:
®
Server Compute Blade SBXL52 ISMP firmware from your Intel
.
Enabled
to
is selected; then, press Enter.
®
Server Compute Blade SBXL52 integrated systems
®
Server Compute Blade SBXL52.
Blade Tasks
Planar Ethernet 2,
to
you
.
®
Server Compute Blade
Firmware Update in
-->
21
Advertisement
Table of Contents
