Table of Contents
Advertisement
e00_VDH_M814.book Page 15 Thursday, October 28, 2004 9:59 AM
2. RECORDING
FULL indicator
Recording
Follow the steps below to record the monitored image onto
the hard disk.
When using the recorder for the first time, check that the TV
SYSTEM selector switch on the rear panel is set to "NTSC"
correctly. If this switch is set incorrectly, recording will not
be performed correctly. ( P.8)
1
Press the [REC/STOP] button.
The REC/STOP indicator lights. "REC" appears on
the screen, and recording starts.
Recording
REC
symbol
0 5 - 1 0 - 0 4 0 8 : 3 0 : 3 5
When you record for the first time, the default
settings are used. To change the image quality.
( P.43)
When the OVER WRITE recording setting is
"ON", the DVR starts recording from the
beginning again. When it is "OFF" and the
remaining space reaches zero, recording stops
and the FULL indicator lights. ( P.44)
You can record and play back images at the
same time. ( P.19)
You cannot change the menu during recording.
15
1
2
3
4
H I
A
[TIMER] button
[REC/STOP] button
To end recording
2
Press the [REC/STOP] button for about
3 seconds.
The REC/STOP indicator turns off and recording stops.
Advertisement
Table of Contents
