Univex Max series 8512 Instruction Manual page 7

8512
Never use detergents nor wash the slicer or any of its parts is a dishwashing machine or the
clear protective finish will be damaged.
Warning 5. Wash body of slicer using warm water and mild soap using a clean soft cloth. Under no
circumstances should the slicer be hose rinsed. It is recommended that the cloth be folded
over a thin wooden stick when cleaning between the fence plate and the knife.
6. Remove knife guard (Figure 1 [5]) by loosening knife guard knob (Figure 3 [35]) and pushing
the long stud upward to lift knife guard above surface of knife. Then carefully lift and remove
guard.
7. Remove deflector (Fig. 3 [33]) by unscrewing knob (Fig. 3 [31 ]).
WARNING: 8. CAREFULLY wash the front and rear of the knife with a cloth using warm water and mild
soap. It is recommended that the cloth be folded over a thin wooden stick as a further caution
to avoid accidental contact with the knife. CAREFULLY wash between the knife edge and
protective guard using a soft cloth inserted between knife edge and guard on both front and
rear of knife using extreme caution to never touch the knife edge. Rinse with warm water
applied with a cloth. Dry thoroughly with a clean soft cloth.
Caution: 9. Following cleaning, a commercial non-toxic sanitizer may be wiped on the clean surfaces
with a soft clean cloth or sprayed as recommended on the container labeling. It is important
that the sanitizer be compatible with anodized aluminum or the clear protective finish on the
slicer will be damaged. Surface should be wetted completely, but not to the point of running
or puddling.
Warning: 10. Replace the knife guard. Never leave the slicer without its knife guard installed!
11. Replace Knife deflector (Fig. 3 [33]).
Page 6