Repair Instructions Including Disassembly, Replacement And Reassembly - Univex Max series 8512 Instruction Manual

(including disassembly, replacement and reassembly)
KNIFE (Removal) (Figure 3)
1. WARNING Disconnect electrical power cord.
2. Remove carriage assembly (Fig. 6).
3. Remove knife guard knob (Fig. 3 [35]) and carefully remove knife guard.
4. Loosen sharpener lock pin (Fig. 7 [13]), lift and relock in up position.
5. WARNING Using caution to avoid the sharp knife edge, remove the four screws (Fie. 3 [ 15]).
6. Carefully remove knife and set aside with its flat side down flush on a bench so the edge is
not exposed.
7. Reinstall new knife in the reverse procedures outlined above.
8. Even though a new knife is very sharp, the sharpening procedure specified on pages 6 and 7
should be performed to true the new knife's bevel to the slicer.
WARNING: Worn knife should be disposed of in a safe responsible way, showing concern for
others who may handle it. It recommended that the edge of the knife be wrapped
several times with heavy tape and that a caution (CAUTION, SHARP EDGE) be
written on both sides of the knife.
KMFE SEAL (Figure 3)
1. Remove knife per above instructions.
2. Unscrew and remove tapered bushing (Fig. 3 [ 12]). Maintain shims that may have been used
in assembly.
3. Using a small screwdriver, carefully pry and remove the knife seal (Fig. 3 [13]) from knife
support (Fig.3 [8]).
4. Apply light film of mineral oil on outer diameter and lip of rubber seal.
KNIFE SUPPORT Figure 3
1. KNIFE SUPPORT ASSEMBLY
A. Remove knife per above instructions.
B. Loosen lama (Fig. 3 [36]) by holding tapered bushing (Fig. 3 [12]) while turning lama
with allen wrench.
C. Elevate left side or lama side of machine 3-1/2" to prevent oil from spilling.
D. Remove oil.
REPAIR INSTRUCTIONS
Page 9
8512