Assembly; Fence Casting; Fence; Featherboard - Jet JWS-25X Operating Instructions Manual

Assembly

Figure 1

Fence Casting

1. Place the fence casting (B) onto the table of
the cabinet (A).
2. Line up the threaded ends of the lock
handles (B ) with the threaded mounting
1
holes (A ) on the table. Tighten the lock
1
handles but allow sufficient slack to permit
the fence to be adjusted backward and
forward.

Fence

1. Place a plastic flat washer (Q) on the fence
lock knob (P). Insert the threaded end of the
lock knob through the slotted opening (B
from the back of the casting (B). From the
front side, attach a slide (R) to the threaded
end of the lock knob (P) and tighten the
knob several turns.
2. Install a fence (M) by engaging the track on
the rear of the fence with the slide (R).
3. Tighten the lock knob (P), but allow enough
slack to permit the fence (M) to slide.
4. Repeat above steps to install the remaining
fence.

Featherboard

Loosen lock handles (N
featherboard (N) so the squared edges of the
carriage bolt underneath the lock handles (N
engage in the track along the top of the
fence (M).

Cutter Guard

Place flat washers (J) on two lock knobs (H).
Insert lock knobs through the slotted openings
on the cutter guard (C) and secure to the
threaded mounting holes (B
casting (B).

Handwheel Handle

Thread handle (F) onto the handwheel (F
tighten with the 12mm wrench (V) provided.
10
) and slide the rail of the
1
) on the fence
3
) and
1
)
2
)
1