Operating Controls; Start/Stop - Jet JWS-25X Operating Instructions Manual

Preset settings
The precision miter gauge has preset settings at
the 45º left, 90º and 45º right positions. To select
one of these settings:
1. Release the lock handle (B, Fig. 14).
2. Flip the plate stop (D) up so it rests on the
miter bar (C).
3. Adjust the body (A) until the stop screw (G)
for the selected angle presses against the
plate stop (D).
4. Tighten the lock handle (B).
Note: If any of the preset settings are not
accurately indicated on the scale:
1. Verify first that the miter gauge is properly
calibrated (see Calibrating the miter gauge
above).
At each preset setting that does not correctly
indicate the setting:
2. Loosen the lock nut (H, Fig. 14).
3. Adjust the set screw (G) until the correct
setting is indicated.
4. Tighten the lock nut (H).

Operating Controls

Start/Stop

Referring to Figure 15:
The JWS-25X shaper is equipped with a
pushbutton control system and reversing switch.
The green start (A) and red stop (B) pushbuttons
are mounted in a control enclosure on the front
of the machine.
To start the machine
1. Unlock the spindle (see Unlocking the
Spindle on page 17).
Before starting the machine,
make sure that the spindle is unlocked.
Failure to comply can cause damage to the
machine.
2. Set the forward/reverse switch (C) as
required.
Do
forward/reverse switch while the motor is
running. Wait until the spindle comets to a
complete stop.
not operate the
3. Press the green start button (A).
To stop the machine
4. Press the red stop button (B).
Note: The red stop button also acts as an
overload reset button. If overload should trip,
reset by depressing the red stop button.
19
Figure 15