Slave Terminal Setup - Omron E2E series Network Connection Manual

7.2. Slave Terminal Setup

Set up Slave Terminal.
7.2.1. Hardware Settings
Configure Slave Terminal, set hardware switches, and connect Proximity Sensor.
Precautions for Correct Use
Make sure that the power supply is OFF when you set up.
1
Make sure that EtherCAT
Coupler Unit and IO-Link Master
Unit are powered OFF.
*If either of them is ON, the
settings described in the
following steps and subsequent
procedures may not be
applicable.
2
Connect IO-Link Master Unit to
EtherCAT Coupler Unit.
3
Check the position of the
hardware switches on EtherCAT
Coupler Unit by referring to the
figure on the right.
7．IO-Link Connection Procedure
EtherCAT Coupler Unit
IO-Link Master Unit
End Cover
Rotary switches
Dip switch
13