Table of Contents
Advertisement
10
2.6.3
Setup location
The device may not be operated outside.
2.7
Installation and Setup
The initial installation and setup is performed by the manufacturer's own ser-
vice personnel or by an authorized dealer/distributor. The device is only re-
leased to the owner when installation is complete and the system is ready for
use.
If the device has not been used for a long period of time then it must first be
inspected by our customer service department or by another authorized com-
pany before being put back into operation again.
The device is operated with an external timer.
A timer must be attached so that the device automatically switches off by
reaching <110 % of the selected running time even if the controller fails. This
device's running may not be exteneded. Safeguards, including the timer
and equipment software of the the unit, are designed to prevent operation
beyond the prescribed time.
Depending on the local utilities company, the devices can transmit interfer-
ence to the power system of the building that impair the audio-frequency
remote control system used by the utility company. This can, for example,
interfere with the function of night-storage heaters.
If faults occur due to the operation of the devices, then the operator is re-
sponsible for the installation of an audio frequency blocking device in the
buildings electrical installation. Please contact your electrician. The electrician
is familiar with the technical connection conditions of your local utility com-
pany so that the audio-frequency blocking device can be matched to the
power system of your utility company.
2.8
Operation and maintenance
Error-free operation, maintenance and service are required in order to ensure
that the health and safety of the users is not endangered during operation and
to ensure that the device is in a fault-free operating condition.
Please observe the information and recommendations provided in these op-
erating instructions. Please ensure that the intervals for the inspection, main-
tenance and service are complied with. Please ensure that the lamps are
replaced after the specified usage time.
Unauthorized modifications and changes to the device and its control unit are
prohibited. Failure to comply with this voids the warranty! Operation of this
system beyond the scope outlined by JK Products & Services relieves JK
from any liabilities resulting from the unapproved operation.
Information for the operator
Hide quick links:
Advertisement
Table of Contents
