Sata Mode (Advanced Menu) - Clevo NB55TK1 User Manual

SATA Mode (Advanced Menu)

You can configure SATA (Serial ATA) control to operate in AHCI (Advanced Host
Controller Interface) or Intel RST Premium With Intel Optane System Acceler-
ation (or RAID - Redundant Array of Independent disks) modes from this menu.
The SATA Mode should be set BEFORE installing an operating system, and after
you have backed up all necessary files and data (see sidebar). See
RAID, Optane™ or AHCI Mode" on page 6 - 2
the Intel Rapid Storage Technology application if you have set the SATA Mode
to RAID, or to AHCI (see
If you wish to change your SATA mode to/from AHCI/Intel RST (RAID) mode you
will receive a message (see overleaf) to notify you that doing so may prevent your
operating system from booting, and may require a reinstall of the OS. If you do wish
to change the SATA mode then backup any necessary data on your hard disk(s) as
you will need wipe the disks clean in order to prevent system problems.
for details. Make sure you install
"IRST Driver Installation" on page 6 -
If you have installed the
"Setting Up SATA
Windows OS with either
AHCI
(RAID) mode enabled,
DO NOT disable the set
41).
mode (if you wish to dis-
able the set mode you
will need to reinstall the
Windows OS).
SATA Mode Change
Advanced Menu 5 - 11
BIOS Utilities

SATA Mode
Selection
or Intel RST
5
Figure 5 - 5
Notification