Sata Mode (Advanced Menu); Power On Boot Beep (Advanced Menu); Battery Low Alarm Beep (Advanced Menu) - Clevo N850HP6 User Manual

SATA Mode (Advanced Menu)

The SATA (Serial ATA) control is configured to operate in AHCI (Advanced Host
Controller Interface) mode or in Intel RST Premium (for Intel
The SATA Mode should be set BEFORE installing an operating system, and after
you have backed up all necessary files and data (see sidebar). See
Mode (Optane™ or AHCI)" on page 6 - 2
tel Rapid Storage Technology application if you have set the SATA Mode to Intel
RST Premium, or to AHCI (see
If you wish to change your SATA mode to/from AHCI/Intel RST (Optane) mode
note that doing so may prevent your operating system from booting, and may require
a reinstall of the OS. If you do wish to change the SATA mode then backup any nec-
essary data on your hard disk(s) as you will need wipe the disks clean in order to pre-
vent system problems.

Power On Boot Beep (Advanced Menu)

Use this menu item to enable/disable the beep as the computer starts up.

Battery Low Alarm Beep (Advanced Menu)

Use this menu item to enable/disable the battery low alarm beep.
for details. Make sure you install the In-
"IRST Driver Installation" on page 6 -
Optane ) mode.
® ™
Intel® Optane™ is a combi-
nation of a compatible
"Setting Up SATA
memory device and Intel
Rapid
ware. This combination is
designed to speed up your
19).
system performance.
Contact your distributor or
supplier to see if your sys-
tem supports this technolo-
gy.
If you have installed the
Windows OS with either
AHCI or Intel RST (Op-
tane) mode enabled, DO
NOT disable the set mode
(if you wish to disable the
set mode you will need to
reinstall the Windows OS).
Advanced Menu 5 - 11
BIOS Utilities

™
Intel®
Optane
Technology soft-
SATA Mode
Selection
5