6.2
OTHER SETTINGS
6.2.1 Restore Factory Calibration
• To restore this calibration value it is necessary to do a simple
procedure. Press and hold the [Zero] key down for 3 seconds to put
the scale into a weighing display.
• Press the [Total] key, the scale will beeps. The Factory Calibration
will be restored to the balance.
6.2.2 Shortcut to Calibration without using Functions
To calibrate the scale without entering the function menu press
•
and hold the [MC/ ] key while power is turned on. The scale will
immediately go to the calibration function.
The display will show the following:
•
Proceed with calibration as normal. See section 5.4.4. When
•
completed the scale will return to normal operation. You cannot
proceed to any other functions from this entry point.
P a g e
41 |
" CAL "
" 0.000 " " 12345"
© Adam Equipment Company 2009