Clearaudio Emotion SE User Manual page 9

User manual / Bedienungsanleitung
The following instructions are for
If you use a tonearm and / or cartridge from different manufacturer please follow the instruction
manual of the particular manufacturer.
3.1 Tonearm set-up
1.)
Satisfy Carbon
Take the
the signal cable and then the tonearm shaft
into the hole of the tonearm base at the right
Emotion SE
upper corner of the
chassis. Please ensure that the tonearm tube
is parallel to the side edge of the chassis
turntable. Tighten the tonearm only slightly
with the provided hex wrench and screws.
Before you finish the tonearm setup, please proceed with the cartridge setup.
The correct height adjustment that is going to be used for the tonearm is depending on the cartridge
you install.
2.)
For the next steps, please mount your cartridge on your tonearm (optional as a package:
Satisfy Carbon
Clearaudio
Use the manufacturer's instruction manual during this installation procedure and follow the
appropriate instructions.
The headshell wires (cartridge connection leads) are colour coded according to the international
standard:
Signal left channel
!
Signal ground left channel
Signal right channel
Signal ground right channel
Please pay attention on every step to avoid any damages to the cartridge!
Now adjust the tracking force of the cartridge.
Please follow the instructions according the manual of the cartridge you use.
If you are using a Clearaudio Moving Magnet cartridge you can adjust the tracking force or the
wiring of the tonearm (about 20 mN), by turning the tonearm`s counter weight on the threaded bolt
(backside view of the tonearm).
Made in Germany
Emotion SE
tonearm and slide first
turntable
tonearm). Please leave the stylus protector on the cartridge.
Satisfy Carbon
Colour code of the
packages.
Pic. 7: Setup of the tonearm
tonearm wire:
white
(L+) >>
blue
(L-) >>
(R+) >> red
green
(R-) >>
9