Ford VSG-411 Service Manual page 108

06-6 Governor
06-6
REMOVAL AND INSTALLATION
Removal
Installation
1.
2.
3.
4.
5.
Disconnect hand throttle
variable speed lever.
connection at governor
Disconnect governor to carburetor throttle control rod
at governor.
Loosen governor mounting nuts and bolts and
governor towards engine to loosen drive belt.
move
Remove drive belt from governor pulley.
Remove governor to bracket attaching bolts and
remove governor.
1.
Position the governor to the mounting bracket and
install the attaching bolts snugly.
2.
Position drive belt to governor pulley and move the
governor away from the engine to tighten the belt.
Tighten the attaching bolts.
3. Adjust the belt tension.
4. Connect the governor to carburetor throttle control
rod. Adjust the rod as described previously.
5. Connect hand throttle cable to governor variable
speed lever. Adjust cable as necessary to permit
operation from idle to maximum speed.