Removal And Installation; Fuel Pump Assembly; Specifications - Ford VSG-411 Service Manual

Hide thumbs Also See for VSG-411:
Table of Contents

Advertisement

03-6
Fuel System
03-6
REMOVAL AND INSTALLATION
Fuel Pump Assembly
Removal
1.
Disconnect the inlet and outlet lines at the fuel pump.
2.
Remove the pump attaching screws, then remove the
pump and the gasket. Discard the gasket.
Installation
1.
Remove all the gasket material from the mounting
pad and pump flange. Apply oil-resistant
sealer to
both sides of a new gasket and to the threads on the
attaching bolts.
Position the new gasket on the pump flange and hold
the pump in position against the mounting pad. Make
sure the rocker arm is riding on the camshaft
eccentric. (Turn engine over until the fuel pump
eccentric is on the low side of the stroke.)
Press the pump tight against the pad, install the
attaching screws and alternately
tighten them to
specification.
Connect the fuel inlet and outlet lines.
Operate the engine and check for leaks.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vsg-413

Table of Contents