Installation - Samlexpower Evolution Series Owner's Manual

SECTION 2 |
2.0 INSTALLATION GUIDELINES
EVO-RC-PLUS is provided with 10M/33ft, RJ-45 data cable (straight wired). Check the proposed
routing distance of the wire and use longer wire, if necessary.
• Flush mounting of the Remote requires appropriate cut-out in the wall/panel - See Fig 2.1.
Full scale installation Template for panel cut-out and pilot holes for mounting screws is also
provided along with the unit. Take necessary precautions to ensure any wiring/plumbing run-
ning behind the wall/panel is not damaged.
• Route the wire to ensure there are no kinks.
• Use appropriate grommets when the wire is passed through holes in studs/partitions to
prevent damage to insulation.
2.1 TOOLS REQUIRED
Following tools are recommended:
• Phillips head screwdriver
• Knife/Saw
EVO-RC-PLUS Installation Template
A
C
2.2 FLUSH MOUNT INSTALLATION
To flush mount, the wall opening must have at least 2" (5 cm) depth to make room for the
remote and cable. Also, the thickness of wall/panel board at the place of mounting should not be
more than 13 mm to ensure that the RJ-45 / RJ-12 Jack openings are not obstructed (see Fig. 2.3).
6 | SAMLEX AMERICA INC.

Installation

• Level
• Pencil
Cut the wall / panel along the dotted
line with a jig saw.
A to D: 4 pilot holes, 2mm (5/64") diameter for
This will create a pocket in the wall / panel
accepting No. 6 x 5/7", Self Tapping,
for ush mounting the EVO-RC-PLUS.
Flat Head Screws.
Fig 2.1 EVO-RC-PLUS Remote installation details
Thickness of wall where
mounted should be up
to 13 mm / 0.51 in (see below).
• Hand Drill
• Drill Bit (2mm /
131 mm / 5.16 in
146 mm / 5.75 in
160 mm / 6.3 in
BOTTOM VIEW
Flush mounting the EVO-RC-PLUS
5
/ ")
64
B
D