Gearbox Functioning - Audi RS 3 LMS SEQ User Manual


LED 5: continuous yellow: water temperature high. Pay attention, drive out of slipstream and
keep an eye on the values. If no red alarm follows you can continue. If alarm disappears you can
continue pushing.

LED 5: slow blinking green: Right turn light is active.

LED 6: slow blinking red: water temperature too high. Drive out of slipstream and keep an eye on
the values. Some torque reductions will appear but you can continue.

LED 6: slow blinking red + POP UP: Critical water temperature. Audi Sport recommends slowing
down and entering to the pit-lane or stopping in a safe place, to avoid damaging the engine.

LED 7: continuous white: Gearbox oil temperature high. Drive out of slipstream and keep an eye
on the values. You can continue.

LED 8: continuous blue: Intake air temperature high. Drive out of slipstream and keep an eye on
the values if not some torque reductions will appear. You can continue.

LED 8: slow blinking white: Steering initialization needed (it will appear each time the car is
switched on). Turning the steering wheel left and right should disappear. If not, there is a problem
in the electrical steering rack.

LED 1 + LED 5: slow blinking red: Pit limiter is active.

LED 1 + LED 5: slow blinking yellow: Full Course Yellow is active.

LED 1 + LED 5: slow blinking blue: 120 limiter is active.

LED 4 + LED 8: fast blinking green: Hand brake is locked and engine started. Unlock it before
trying to move the car.

LED 4 + LED 8: fast blinking green + POP UP: Hand brake is locked while you are driving. Audi
Sport recommends unlocking the hand brake and entering to the pit-lane to check if the rear brake
callipers have been damaged.
Note:

It is possible to customize the alarms and shift lights through the RaceStudio3 software installed
on a laptop.

Gearbox functioning

R - Reverse mode:

It is possible to put on this R mode if the car is complete stopped and clutch pedal pressed.

In case of clutch pressure sensor malfunction, it is also possible to use the steering wheel (P) Safety
brake signal button to put on or take out the R mode. IMPORTANT: the use of this button is under
user responsibility, a bad use of it may cause fatal damages on the gearbox.
N - Neutral mode:

In N mode, it is possible to move the car pushing externally (pit lane use).

To enter into this mode it is mandatory to press the clutch pedal.

To exit from this mode it is necessary to be completely stopped and pressing the clutch pedal.

It is also possible entering to and exiting from this mode using the steering wheel (P) Safety brake
signal button. IMPORTANT: the use of this button is under user responsibility, a bad use of it may
cause fatal damages on the gearbox.
Driving mode:

It is possible to go from N to 1
Also possible using the steering wheel (P) Safety brake signal button. IMPORTANT: the use of this
button is under user responsibility, a bad use of it may cause fatal damages on the gearbox.

It is possible to put on Neutral mode at any moment only if the clutch pedal is pressed.
st
gear if the car is completely stopped and the clutch pedal is pressed.
13