Audi RS 3 LMS SEQ User Manual page 11

Hide thumbs Also See for RS 3 LMS SEQ:
Table of Contents

Advertisement

Button
Function
Radio
Full Course
Yellow
120 limiter
Cockpit fan
Change display
page
Safety brake
signal button
Diff map
change
Starter
Pit limiter
Drink
Rain lights
Wiper
Windscreen
water
High beam
Tip up / Tip
down
CAN info
Remarks
Driver voice activation
Maintain pushed to talk
4 variable* speeds (40/50/60/80)
Short push to activate/deactivate
Double short push to activate
Single short push to deactivate
Short push to activate/deactivate
Short push to change display page / rolling change
Allows entering to and exiting from N without pressing the
clutch pedal. IMPORTANT: the use of this button is under
user responsibility, a bad use of it may cause fatal
damages on the gearbox
No use on cars with sequential gearbox
Only use on DSG cars.
Active if gearbox is in Neutral or the clutch is pressed
Active if rpm < 500
4 variable* speeds (40/50/60/80)
Active if rpm > 500 and speed
Short push to activate/deactivate
Activates water pump
Note: pump not supplied with the car
Short push to activate/deactivate
Short push to roll low speed/high speed/deactivate
Long push to activate water splash + wiper activation
Short push to flash
Long push to activate/deactivate
A led informs when tip up or down
Usual status: led off
If there is a CAN Bus problem: led on
> 5 km/h
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents