Table of Contents
Advertisement
Insert the Module into the Slot
The modules are installed into the SMC6624M switch as follows:
1. Using a flat-bladed or Torx T-10 screwdriver, unscrew the two retaining
screws on the slot cover plate or existing module, and remove it from
the switch.
Console
Power
Fault
2. Touch a grounded, metal object (such as a powered-on switch) to
discharge any static electricity on your body, then carefully remove the
module from its protective anti-static packaging. Hold the module by
its bulkhead or edges, taking care not touch any of its board components
or metal connectors.
3. Slide the module firmly into the module slot as far as it will go. The
module should "snap" into place, and the module's faceplate should
touch the front panel of the switch. The following illustration shows the
module being installed into the SMC6624M switch.
25
26
1
2
3
4
5
6
7
8
9
10
11 12
Self
Fan
Reset
Clear
Test
Status
4. Using the flat-bladed or Torx T-10 screwdriver, tighten the retaining
screws on the module until they are secure, but be careful that you do
not overtighten the screws.
5. Reset the switch to initialize the module.
25
26
1
2
3
4
5
6
13 14 15 16 17 18
7
8
9
10
11 12
19 20
Self
Fan
Reset
Clear
Test
Status
13
14
15
16
17 18
Link
Act
Link
Act
19
20
21 22
23 24
Link
25
Act
Link
Act
21 22 23 24
loosen these screws and remove the cover plate
25
1000BASE-SX-SC
TX
RX
SMC6624GSSC
26
slide the module into the slot
until it snaps into place
1
7
3
Advertisement
Table of Contents
