Modifying Your Password; Restoring Initial Settings - BITMAIN ANTMINER D3 Installation Manual

proceed to flash the image. (Note: Please do not extract the update file and keep the power on during
updating firmware or otherwise the server needs to be returned to the factory to repair. And around
two minutes will be needed to complete updating.)
3. When the upgrade is completed successfully, the following message will appear: (Screenshot below of S9
server just for your reference to show the message, the message shows on your computer shall prevail).

6.3 Modifying Your Password

To change your login password:
1. In System, click the Administration tab.
2. Set your new password, then click Save & Apply.

6.4 Restoring Initial Settings

To restore your initial settings, two methods below for your reference.
1. Turn on the server and let it run for 5 minutes.
2. On the controller front panel, press and hold the Reset button for 10 seconds.
Resetting your server will reboot it and restore its default settings. The red LED will automatically
flash once every 15 seconds if the reset is operated successfully.
- 15 -
D3 Server Installation Guide