Daikin RoofPak RPS Series Installation And Maintenance Manual page 36

Phase III. Reconnecting power and control wiring
The wire harnesses are coiled in the condenser section base
rail (see Figure 54). The power wires into the lower base rail
raceway and the control wires into the upper raceway.
1. Uncoil the harnesses and feed them through the base
rail of the air handler section and make the proper
connections. The power wires terminate to the load side
of the contactors; the control wires plug into the plug
patch panel.
2. The liquid line solenoid valve harness is split into two
harnesses. Install one half in the plug patch panel in the
main control box (see
3. The other half of the harness is located in conduit on the
bulkhead of the air handler section (see
4. Terminate the conduit to the vertical raceway in the
condenser section (see
5. Wire nut the ends of the two harnesses together.
6. The optional hot gas bypass solenoid valve harness
is coiled in the upper raceway of the condenser base
rail (see Figure 55). Route the plug end of the harness
through the air handler raceway and into the main control
cabinet and plug into the plug patch panel.
IM 926-3 • ROOFPAK APPLIED SYSTEMS
Figure 54).
Figure 54).
Figure 55).
Figure 54: Connecting Power/Control Wiring (015C - 040C)
Figure 55: Remove Vertical Raceway
36
Mechanical Installation
www.DaikinApplied.com