Service And Maintenance; Error Messages; Disposal - Siemens SENTRON 7KT PAC1200 System Manual

Service and maintenance

6.1

Error messages

The Status LED does not light up
Problem: The Data Manager is not supplied with power.
Solution: Ensure that at least the line conductor L1 and the neutral conductor N are
connected to the Data Manager.
The Status LED lights up or flashes red.
Problem: There is a fault.
Solution: Restart Data Manager.
Solution: Contact Service.
The network LED does not light up, or the Data Manager is not found in the network.
Problem: The network cable is not correctly connected to the network connection.
Solution: Ensure that the network cable is correctly connected to the network connection.
Problem: The Data Manager is not located in the same local network.
Solution: Connect the Data Manager with the same router / switch, or change the IP address
in the PC.
The Energy Manager supplies unrealistic measured values.
Problem: The Data Manager has been installed incorrectly.
Solution: Check connection of L1 to L3 again.
6.2

Disposal

The system must be disposed of in accordance with the locally applicable regulations for the
disposal of electronic waste.
7KT PAC1200 multichannel current measuring system
System Manual, 11/2016, 2514374103-02
6
55