General; Tools Required For Installation (Not Supplied); Accessories Supplied With Outdoor Unit; Type Of Copper Tube And Insulation Material - Sanyo C4272R S/C Installation Instructions Manual

07-115 SSHP_II 5/7/07 3:59 PM

1. GENERAL

This booklet briefly outlines where and how to install
the air conditioning system. Please read over the
entire set of instructions for the indoor and outdoor
units and make sure all accessory parts listed are
with the system before beginning.

1-1. Tools Required for Installation (not supplied)

1. Standard screwdriver
2. Phillips head screwdriver
3. Knife or wire stripper
4. Tape measure
5. Level
6. Sabre saw or key hole saw
7. Hacksaw
8. Core bits
9. Hammer
10. Drill
11. Tube cutter
12. Tube flaring tool
13. Torque wrench
14. Adjustable wrench
15. Reamer (for deburring)

1-2. Accessories Supplied with Outdoor Unit

See Tables 1-1 to 1-9.
Table
1-1 4-Way Air Discharge Semi-Concealed
1-2 Wall-Mounted
1-3 Ceiling-Mounted
1-4 Concealed-Duct
1-5 Outdoor Unit
1-6 Wired Remote Controller
1-7 Wireless Remote Controller
1-8 Timer Remote Controller
1-9 System Controller
Page 8
Type

1-3. Type of Copper Tube and Insulation Material

Copper tubing for connecting the outdoor unit to the
indoor unit is available in kits which contain the liquid
and gas tubing, fittings and insulation. Consult your
nearest sales outlet or A/C workshop.
If you wish to purchase these materials separately
from a local source, you will need:
1. Deoxidized annealed copper tube for refrigerant
tubing.
2. Foamed polyethylene insulation for copper tubes
as required to precise length of tubing.
Wall thickness of the insulation should be not less
than 5/16 in.
3. Use insulated copper wire for field wiring. Wire size
varies with the total length of wiring. Refer to
Section 5. "Electrical Wiring" for details.
Check local electrical codes
CAUTION
and regulations before
obtaining wire. Also, check
any specified instructions
or limitations.

1-4. Additional Materials Required for Installation

1. Refrigeration (armored) tape
2. Insulated staples or clamps for connecting wire
(See your local codes.)
3. Putty
4. Refrigeration tubing lubricant
5. Clamps or saddles to secure refrigerant tubing
6. Scale for weighing
8