Sanyo C4272R S/C Installation Instructions Manual page 36

07-115 SSHP_II 5/7/07 3:59 PM
KHH(S)2672R
Remove and discard the set screws and take off the
wall fixture. (Fig. 3-29)
KHH(S)2672R
(1) Tape the full-scale installation diagram on the wall
at the location selected. Make sure the unit is hori-
K
zontal using a level or tape measure to measure
down from the ceiling. (Fig. 3-30)
(2) Before drilling a hole, check that there are no studs
or pipes behind the determined location.
CAUTION
(3) Using a sabre saw, key hole saw or 3-5/32 in.
hole-cutting drill attachment, make a hole in the
wall. The required minimum hole diameter for
these models is 3-3/16 in. (Fig. 3-31)
(4) Measure the thickness of the wall from the inside
edge to the outside edge and cut PVC pipe at a
slight angle 1/4 in. shorter than the thickness of
the wall. (Fig. 3-32)
(5) Place the plastic cover over the end of the pipe,
(for indoor side only) and insert in the wall.
(Fig. 3-33)
Page 36
Avoid any area where electrical
wiring or conduit is located.
Also take this precaution if the
tubing goes through a wall at
any other location.
Wall fixture
Set screws only for transportation
Fig. 3-29
F
u
l l s -
c
a
e l
n i
s
Fig. 3-30
NOTE
Hole should be made at a slight dowward slant to the
outdoor side.
Indoor
side
Fig. 3-31
PVC pipe (locally purchased)
Fig. 3-32
INSIDE
Plastic
cover
Fig. 3-33
36
Tape
a t
l l t a
o i
n
d
a i
g
a r
m
Outdoor
side
Cut at slight angle
OUTSIDE
Wall
PVC pipe
Slight
angle