Xerox VersaLink C505 User Manual page 231

Symptom
Partial blanks, creased paper, or
blotted printing.
Vertical blanks appear.
Probable Causes
There is debris on the transfer belt.
The paper is damp.
The paper is outside the
recommended specification range.
A printer part is worn or damaged.
The toner cartridges are not
Xerox ® toner cartridges.
The paper is impeded in the paper
path.
Condensation inside the printer
causes partial blanks or creased
paper.
The laser lenses are blocked.
A printer part is worn or damaged.
The toner cartridges are not
Xerox ® toner cartridges.
Xerox ® VersaLink
Solutions
Xerox Support website at
®
xerox.com/office/VLC505support.
At the printer control panel,
perform a transfer belt cleaning
procedure. For details, refer
toPerforming a Transfer Belt
Cleaning Mode
Replace the paper.
Replace the paper with a
recommended size and type. For
details, refer to
For assistance, go to the
Xerox ® Support website at
xerox.com/office/VLC505support.
Verify that the toner cartridges
meet specifications and replace if
necessary. For details, refer to
Consumables.
• Remove any paper or debris
from the paper path.
• Ensure that the trays are
pushed in all the way.
• Ensure that the rear cover is
closed and locked.
Power on the printer and leave it
on for at least 1 hour to get rid of
the condensation. For assistance,
go to the Xerox ®
at www.xerox.com/office/
VLC505support.
Clean the laser lenses. For details,
refer to Cleaning the LED
For assistance, go to the
Xerox Support website at
®
xerox.com/office/VLC505support.
Ensure that the toner cartridges
meet specifications and replace if
necessary.
® C505 Color Multifunction Printer
Troubleshooting
www.
Procedure.
Supported Paper.
www.
Support website
Lenses.
www.
231
User Guide