Table of Contents
Advertisement
4. Select [SUB1 INPUT] using the ▼/▲ buttons, and
press the ENTER button.
This displays the [SUB1 IMPUT] screen.
5. Select an input signal for SUB 1 using the ▼/▲ but-
tons and press the ENTER button.
The display returns to the PICTURE BY PICTURE
screen.
6. Perform the same steps as 4 and 5 to select input
signals for SUB2 and SUB3.
7. Press the MENU button.
The on-screen menu will disappear.
• To return to a single screen, select [OFF] from the MODE select screen in Step 3.
TIP:
• To project two screens, select [DUAL] in the step 3, and select the input signal for SUB1 in the steps 4 and 5.
• In the case of projecting two screens, you can set the orientation of screen to the portrait position or adjust the display position.
(→ page 95, 96)
Restrictions
• The following operations are enabled only for the main display.
• Visual adjustments
• Video magnification / demagnification using the partial D-ZOOM/ZOOM +/− buttons.
• The following operations are enabled for MAIN, SUB1, SUB2, and SUB3. These operations cannot be applied
individually.
• Momentary deletion of video (AV Mute)
• Video pause (Freeze)
• When TEST PATTERN is displayed, the single screen is projected.
• In the following cases, PICTURE BY PICTURE cannot be used.
• When [PICTURE SETTING] → [MODE] is set to [ZOOM] or [TILING]
• When MAIN is set to SDI1 and [SDI LINK] is set to other than [SINGLE]
• When MAIN is set to DisplayPort 1 and [DP LINK] is set to [DUAL]
• The following operations cannot be made when [PICTURE BY PICTURE] is used.
• DYNAMIC CONTRAST
• IMAGE OPTIONS (when MODE is set to [DUAL] and [PORTRAIT ANGLE] is set to [90°] or [270°])
• ASPECT RATIO (when MODE is set to [QUAD])
59
4. Multi-Screen Projection
Advertisement
Table of Contents
