Table of Contents
Advertisement
RESET
Reset the adjustment value that has been selected in [GEOMETRIC CORRECTION] (return to the initial value). It
becomes ineffective when [OFF] is selected for [MODE].
• The adjusted value can be reset also by pressing the 3D REFORM button for two seconds or longer on the remote
control.
[EDGE BLENDING]
This adjusts the edges (boundaries) of the projection screen when projecting high resolution videos using a combina-
tion of several projectors in the up, down, left and right positions.
MODE
This enables or disables the EDGE BLENDING function.
When [MODE] is set to [ON], the [MARKER], [TOP], [BOTTOM], [LEFT], [RIGHT], [BLACK LEVEL] and [BLEND
CURVE] settings can be adjusted.
MARKER
Set whether to display marker or not when adjusting the range and display position. When turned on, a magenta
marker for adjusting the range adjustment and a green marker for adjusting the display position will be displayed.
TOP/BOTTOM/LEFT/RIGHT
This selects the EDGE BLENDING locations on the left, right, top and bottom on the screen.
The following settings can be adjusted when an item is selected. (→ page 64)
CONTROL �������������� Enable TOP, BOTTOM, LEFT and RIGHT functions�
RANGE ������������������� Adjust the range (width) of the edge blending�
POSITION �������������� Adjust the display position of the edge blending�
BLEND CURVE
Set brightness for the [EDGE BLENDING] sections. (→ page 68)
BLACK LEVEL
Adjust the black level of the [EDGE BLENDING] section. (→ page 69)
101
5. Using On-Screen Menu
Advertisement
Table of Contents
