Table of Contents
Advertisement
2. Adjust the focus at the edges of the projected image.
Press the ZOOM button to display the zoom adjustment bar. Press the ◀▶ button to adjust the focus around the
screen.
Focus around the optical axis set at step 1 is remained unchanged.
3. Repeat steps 1 and 2 until the optimal focus can be obtained on whole image.
TIP:
• To obtain the best focus, perform the following (for permanent installation)
Preparation: Warm up the projector for one hour.
1. Use the FOCUS button and the ◀▶ buttons to make sure you obtain the best focus. If you do not, move the projector back and
forth.
2. Select the [TEST PATTERN] from the menu and display the test pattern. (→ page 79)
• You can also use the TEST button on the remote control to display the test pattern.
3. Press the FOCUS button to display the Focus Adjustment Bar, then press the ◀ button until the pixel lattice of the test pattern
cannot be seen any more.
• The FOCUS adjustment bar displaying position can be shifted or be turned off temporarily. (→ page 36)
4. Keep pressing the ▶ button until you obtain the best focus.
If you adjust beyond the best focal point, go back to step 3 and repeat the procedures.
5. Press the ZOOM button to display the zoom adjustment bar and press the ◀▶ button to adjust the focus around the screen.
Press the D-ZOOM/ZOOM +/− button holding to press the CTL button for adjusting it by the remote control.
Repeat steps 1 to 5 until the optimal focus can be obtained on whole image.
2. Projecting an Image (Basic Operation)
Optical axis
30
Advertisement
Table of Contents
