Table of Contents
Advertisement
Applicable lens unit: NP31ZL-4K
1. Focus on the projected image around the optical axis. (Powered focus)
Press the FOCUS button to display the focus adjustment bar. Press the ◀▶ button to adjust the focus near the
optical axis.
• On the remote control, while pressing on the CTL button, press on VOL/FOCUS (+) or (−) button.
• ◀ or ▶ buttons on the remote control are also available to adjust FOCUS while the FOCUS adjustment bar is
displayed on.
The drawing below shows an example when the projected image is shifted upward. In this case the optical axis
is at the bottom edge of the projected image.
* When the lens is at the center position, the optical axis is at the
center of the image. In this case, adjust the focus at the center of
the projected image.
2. Projecting an Image (Basic Operation)
27
Optical axis
Advertisement
Table of Contents
