Terex TR60 Maintenance Manual page 82

Transmission - CEC Plus II Shift System
Section 120-0070
ECU Electromagnetic Shield - Ground
Refer to Fig. 15. Must be grounded to protect ECU.
Mode Selection Switch
Refer to Fig. 16.
1. With mode selection switch in Economy (open)
position, ECU will control transmission as per the
Economy mode shift schedule.
MODE
SELECTION
SWITCH
Manual Mode Switch
Refer to Fig. 17.
1. With ignition keyswitch at position '2' and manual
mode switch 'On' (closed) indicator light on console
will illuminate.
2. When mode selection switch is in the Power
(closed) position and manual mode switch is in the
'On' (closed) position, Lines 311, 313 and 315 are all
24V SUPPLY
FROM IGN. SWITCH
12
Fig. 16 - Mode Selection Switch
IND. LIGHT
MANUAL
MODE
SWITCH
Fig. 17 - Manual Mode Switch
Fig. 15 - ECU Electromagnetic Shield - Ground
2. With mode selection switch in Power (closed)
position, Lines 313 and 315 are connected to Line 309
and the ECU will then control the transmission as per
the Power mode shift schedule.
SECONDARY MODE
HARNESS - J3
connected to Line 309 and ECU will change operation
of transmission from automatic to manual.
Note: Both switches must be closed and transmission
in neutral to obtain manual mode.
Note: CEC wires B (309) and 311 are 12 volt and
W/B wires at manual mode switch are 24 V. Improper
connection of wires could lead to CEC damage.
MODE
SELECTION
SWITCH
SM - 426
GROUND TO
PASSENGER
SEAT BOX
SM - 429
SM - 430
SECONDARY MODE
HARNESS - J3
SM 1575 Rev 2 11-00