Terex TR60 Maintenance Manual page 141

WHEEL
Removal and Disassembly
Numbers in parentheses refer to Fig. 6.
WARNINGS
To prevent personal injury and property
damage, be sure wheel blocks, blocking
materials and lifting equipment are properly
secured and of sufficient capacity to do the
job safely.
To prevent personal injury and property
damage, completely deflate tyre by removing
the valve cap and core. Insert a thin wire
through valve to be sure valve is not plugged.
Even a flat tyre, in some cases, will retain
sufficient air pressure to blow off a rim
component with enough force to cause injury
or death.
SM 1579 12-98
Fig. 6 - Sectional View of Front Wheel Assembly.
Front Axle - Wheel, Rim and Tyre
BRAKE CALLIPER
SEC 165-0020
1. Block the front and rear of all wheels, except the
one to be raised. Jack up or lift machine so its weight
is no longer on that wheel.
2. Deflate tyre completely, and remove the tyre and
rim assembly from the wheel. Follow instructions
under 'Removing Tyre and Rim Assembly'.
WARNING
To prevent possible personal injury, relieve
the pressure in the braking system. The exact
procedure must be followed as described in
Section 250-0000, BRAKING SYSTEM
SCHEMATIC.
3. Relieve the pressure in the braking system. Refer
to Section 250-0000, BRAKING SYSTEM
SCHEMATIC. Disconnect brake hydraulic line at
brake calliper.
Section 140-0040
SM - 229
1 - Lockwire
2 - Bolt
3 - Plate
4 - Shim Pack
5 - Outer Bearing Cone
6 - Outer Bearing Cup
7 - Wheel
8 - Spindle
9 - Inner Bearing Cone
10 - Inner Bearing Cup
11 - Washer
12 - Snap Ring
13 - Seal
14 - Bushing
15 - Bolt
16 - Lockwasher
17 - Brake Disc
18 - Bolt
19 - Lockwasher
20 - Cover
21 - Gasket
5