Terex TR60 Maintenance Manual page 260

Fuel System - Electronic Foot Pedal
Section 200-0051
2. Turn steering wheel in both directions several times
to relieve any pressure in the steering circuit. Block all
road wheels.
3. Disconnect electrical harness (31) from the mating
engine and transmission harnesses.
4. Move cab floor mat back and clear from pedal
assembly (1) and mounting plates.
5. Remove mounting bolts (8) and lockwashers (9)
securing plate assembly (10) and pedal assembly (1)
to cab floor plate. Remove plate assembly (10) and
pedal assembly (1).
6. Remove bolts (17) and lockwashers (18) securing
pedal assembly (1) to plate assembly (10). Remove
pedal assembly (1) from plate assembly (10).
INSTALLATION
Numbers in parentheses refer to Fig. 1.
Note: Tighten all fasteners to standard torques listed
in Section 300-0080, STANDARD BOLT AND NUT
TORQUE SPECIFICATIONS.
2
1. Position pedal assembly (1) on plate assembly (10)
and secure with bolts (17) and lockwashers (18).
2. Secure plate assembly (10) and pedal assembly (1)
to the cab floor plate with mounting bolts (8) and
lockwashers (9) removed during removal.
3. Connect electrical harness (31) to the mating
engine and transmission harnesses.
4. Position floor mat on cab floor and ensure that pedal
assembly (1) is free to operate.
5. Remove wheel blocks and start the engine. Ensure
that pedal assembly (1) operates correctly.
Note: The engine MUST be started with the foot 'OFF'
pedal assembly (1).
MAINTENANCE
Limited repair of the electronic foot pedal assembly is
by replacement of parts only. Refer to vehicle Parts
Book for part numbers of overhaul kits.
* * * *
SM 1196 2-98