Terex TR60 Maintenance Manual page 254

Fuel System - Fuel Tank and Mounting
Section 200-0010
MAINTENANCE
Numbers in parentheses refer to Fig. 1.
Prior to starting the vehicle check the fuel level. Fuel
tank (1) should be filled at the end of each shift to
prevent condensation from gathering in the tank.
Ensure vent hole in filler cap (5) is clear to prevent a
vacuum from building up in fuel tank (1). Check
condition of all fuel lines.
When filling fuel tank (1) check that there is no buildup
of dirt and sludge at fuel strainer (23). Remove and
4
clean fuel strainer (23) and filler cap (5) as required.
From time to time make a visual check on the
electrical connections at fuel level sender (27).
The condition of fuel tank (1) mounting should be
checked carefully. Check heavy duty straps (18) and
mounting brackets (17 & 21) for any sign of wear or
damage and repair or replace as required. Check that
nuts (16 & 19) and bolts (20) are securely tightened
and that no wear on mounting holes is evident. Tighten
nuts (16 & 19) and bolts (20) as required.
* * * *
SM 1587 12-98