Control Panel Features - Westinghouse WGen6000 User Manual

FEATURES

CONTROL PANEL FEATURES

1
START
RUN
STOP
ELECTRICŁ
START
1 Electric Start Switch: Hold in START position until
engine starts. Make sure to set choke prior to cold
starting.
Data Center: The VFT Meter is 4 state LED display
2
that will rotate through volts, frequency, and lifetime
run hours. The 4th display is not used and will
always display 00:00. You can press the MODE
button to cycle through the different displays. The
meter will display volts and hertz even if there is no
load connected.
The frequency and voltage can vary +/- 5% and
still be within tolerance.
Voltage
Frequency in hertz
Lifetime run hours
Inoperative
Main Circuit Breaker: The main circuit breaker
3
controls total output of all outlets to protect the
generator.
14 | Westinghouse Portable Power
2 3
NEUTRALŁ
BONDED TOŁ
FRAME
7
4 5
120V AC 20AŁ
5-20R (GFCI)
120/240V AC 30AŁ
L14-30R
120/240-Volt, 30-Amp Twist Lock Outlet
4
(NEMA L14-30R): Outlet can supply either
120V or 240V output.
120-Volt, 20-Amp Duplex GFCI Outlets
5
(NEMA 5-20R): Each outlet is capable of carrying
a maximum of 20 amps on a single receptacle or
a combination of both receptacles.
20-Amp Circuit Breakers: Each circuit breaker
6
limits the current that can be delivered through
the 120-volt duplex outlets to 20amps.
Ground Terminal: The ground terminal is used to
7
ground the generator.
6
120V AC 20AŁ
5-20R (GFCI)
20A
20A