Adhesive Mounting Installation - Renishaw RGH40 Installation Manual

Adhesive mounting installation

1 Throughly clean and degrease
the substrate with
a lint-free cloth.
Clean underside of glass scale using approved solvents
(see 'Storage and handling').
2 Mark area for epoxy on adhesive tape.
RGH40 RGS40-G
installation guide
3 Remove white/clear backing tape
and stick to underside of scale.
4
Throughly mix and apply epoxy then remove
green backing tape and stick to substrate.
Area for RGG-2 epoxy (A-9531-0342)
5
Locate scale against dowels or ledge and
rotate down onto substrate. Press down
with firm finger pressure
6
Support
dowels
Mounting ledge
7
Remove excess epoxy
8
Allow 24 hours for epoxy to cure fully, then clean
scale using Renishaw scle wipes (A-9523-4040)
or a clean, dry, lint-free cloth.
5