Check, Test, And Start Procedure Form - Daikin SWP Series Installation Manual

Complete this form and return to Daikin Applied, Warranty Department, within 10 days to comply with the terms of Daikin Applied Warranty.
Check, Test, and Start Procedure for SWP/SWT (Self-Contained Air Conditioning Systems)
Job name: _____________________________________________________________
Installation address: _____________________________________________________________________________________________
City: __________________________________________________________________
Purchasing contractor: ___________________________________________________________________________________________
City: __________________________________________________________________
Unit model number: _____________________________________________________
Compressor #1 serial number: _____________________________ Compressor #2 serial number: _____________________________
Compressor #3 serial number: _____________________________ Compressor #4 serial number: _____________________________
Compressor #5 serial number: _____________________________ Compressor #6 serial number: _____________________________
Compressor #7 serial number: _____________________________ Compressor #8 serial number: _____________________________
Mark NA on all items that do not apply to the type of the unit. See the IM bulletin for more information. Make any additional
comments on a separate sheet of paper and attach to this form.
I. Initial Check
A. Is any shipping damage visible? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
B. Is the unit installed level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
C. Is the unit positioned to provide adequate free area for service and operation? . . . . . . . . . . . . Yes
D. Are the fan drives properly aligned and belts adjusted . . . . . . . . . . . . . . . . . . . . . . Yes
E. Does the fan turn freely? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
F. Are all setscrews on pulleys, bearings, and fans tightened?. . . . . . . . . . . . . . . . . . . . Yes
G. Is the entering condenser water temperature sensor located correctly? . . . . . . . . . . . . . . . Yes
H. Has the installing contractor installed the return air temperature sensor in the return air stream? . . . . . Yes
I. Has the installing contractor installed the high and low static pressure sensor tubing in the ductwork? . . . Yes
J. Does electrical service correspond to the unit nameplate? . . . . . . . . . . . . . . . . . . . . Yes
K. Are adequate disconnect and circuit protectors installed? . . . . . . . . . . . . . . . . . . . . Yes
L. Is the unit adequately grounded? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
M. Are all electrical power connections tight? . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
N. Have the compressor heaters operated continuously for 24 hours prior to startup?
O. Does all electrical wiring conform to unit electrical diagram? . . . . . . . . . . . . . . . . . . . Yes
P. Does all field wiring conform to electrical diagrams?
Q. Are all service valves open? . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
R. Have all shipping hold-down plates securing the fan frame been removed? . . . . . . . . . . . . . Yes
S. On unit with ducted return, has the low side tubing for PC5 (dirty filter switch) been installed? . . . . . . Yes
T. Are all the cleanout plugs installed (condenser, condensate trap, and optional waterside economizer)? . . Yes
U. Is the water flow sensor (WFS) installed? . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
II. Start-Up
A. Does the unit start and perform per sequence of operation as stated in the IM bulletin? . . . . . . . . . Yes
B. Does the fan rotate in the right direction? . . . . . . . . . . . . . . . . . . . . . . . . . . . Yes
C. Condenser inlet water temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . _________ °F
D. Condenser outlet water temperature. . . . . . . . . . . . . . . . . . . . . . . . . . . _________ °F
E. Number of compressors operating . . . . . . . . . . . . . . . . . . . . . . . . . . . _________ °F
F. Return air temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . _________ °F
G. Mixed air temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . _________ °F
H. Supply air temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . _________ °F
I. Compressor readings: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . _________ °F
www .DaikinApplied .com
Equipment Warranty Registration Form
. . . . . . . . . . . . . . . . . . . . . . Yes
49
C , T , s
heCk esT and TarT
Daikin Applied G.O. #: ___________________
State: __________________________________
State: __________________________________
Serial number: __________________________
. . . . . . . . . . Yes
IM 1032-2 • Self-Contained Air Conditioning Systems
P f
roCedure orm
C , T , s P f
heCk esT and TarT roCedure orm
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A
No N/A