Panels, Frame Channels, And Doors - Daikin SWP Series Installation Manual

Panels, Frame Channels, and Doors

Panel Removal
To remove a side or top panel, remove the flat head Torx 30
fasteners along the sides of the panel . Lift off the panel after
removing all fasteners .
Frame Channel Removal
Top frame channels that run the length of the unit can be
removed to allow access to both the side and top of the unit . To
remove the frame channel, first remove the side panel(s). Once
the side panel is off, remove the flat head Torx 30 fasteners in
the corner of the frame channels and pull the frame channel
out the side . Remove any panel screws that are within 1" of the
of the frame, since they are engaged into the gasketed flange
of the frame . See Figure 33 .
Figure 33: Removing Panel Screws
www .DaikinApplied .com
Remove any
panel screws that
engage frame
Remove panel
to remove frame
Fan Section Doors
1 . Use a 1/2" socket and rotate 1/4 turn clockwise as shown
in Figure 34 . If the socket and handle are on the left side
of the door, rotate 1/4 turn counterclockwise .
2 . Rotate the door handle 1/4 turn clockwise and then 1/4
turn counterclockwise to release any internal pressure
or vacuum and open the door . If the socket and handle
are on the left side of the door, rotate the door handle 1/4
turn counterclockwise and then 1/4 turn clockwise .
3 . To prevent air leakage, tighten the door panels by
adjusting the jam nuts .
NOTE: Opening the fan section doors requires using a 1/2"
socket wrench, which satisfies ANSI standards and
other codes that require the "use of tools" to access
compartments containing moving parts or electrical
wiring . See Figure
Sharp edges and coil surfaces are a potential injury hazard .
Avoid contact with them .
DO NOT attempt to rotate the cup . Damage to the unit will
occur .
Figure 34: Opening Fan Section Door
45 IM 1032-2 • Self-Contained Air Conditioning Systems
s m
ysTem aInTenanCe
34 .
CAUTION
CAUTION