Daikin SWP Series Installation Manual page 18

Disconnect
The optional disconnect is a molded case switch with many of
the same features of the circuit breaker . The disconnect comes
standard with a through-the-door handle and mechanism
(Figure 16) to disconnect power to the unit prior to opening the
door . The handle can be padlocked in the OFF position while
performing maintenance to the unit .
Molded case switches do not provide over-current protection .
This device may automatically open the circuit at levels above
the ampere rating of the switch .
Figure 16: Through-the-Door Handle Disconnect
Disengage
interlock
mechanism
(located here)
by inserting a
small object here
(a pen works) and
pulling down.
Disengaging interlock exposes high voltage that can
cause severe personal injury or death . Do not touch
exposed components . Wear dry clothes and stand on a
dry,nonconducting surface . Do not wear jewelry . Work with
another trained, experienced technician nearby .
IM 1032-2 • Self-Contained Air Conditioning System
CAUTION
WARNING
Terminals
All field wiring terminals are spring clamp type, which offer
several advantages over traditional screw-type terminals:
• Spring connections do not require torquing
• Spring connections resist failure due to vibration
• Easily identifiable terminal markers
• Combination spring release and square test ports
To insert a wire to the terminal connector:
1 . Insert a small flat-blade screwdriver into the square hole
("1" in Figure 17) to open the spring clamp ("2" in
17) adjacent to the desired wire location .
2 . Strip approximately 1/2" of insulation from the wire .
3 . Insert the stripped wire into the wire terminal ("1" in
Figure 17) .
4 . Remove the screwdriver to close the spring clamp .
Figure 17: Terminal Connectors
1
2
2
1
2
1
18
e d
leCTrICal aTa
Figure
www .DaikinApplied .com