Wolf CGB-75 Installation And Operating Instructions Manual page 8

8
3. Standards and regulations
Requirements
The installation of the boiler must be in accordance with the relevant requirements
of Gas Safety (Installation and Use) Regulations 1998, Health and Safety
Document No. 635 (The Electricity at Work Regulations 1989), BS 7671 (IEE
Wiring Regulations) and the Water Supply (Water Fitting) Regulations 1999, or The
Water Bylaws 2000 (Scotland). It should also be in accordance with the relevant
requirements of the Local Authority, Building Regulations, including amendments to
the Approved Documents Part L and J 2002, The Building Regulations (Scotland),
The Building Regulations (Northern Ireland) and the relevant recommendations of
the following British Standards:
BS 5440: Flues and ventilation of gas fired boilers not exceeding 70 kW net:
- Part 1: Flues
- Part 2: Ventilation
BS 5449: Specification for forced circulation hot water for domestic premises.
BS 5546: Specification for forced circulation hot water for domestic premises.
BS 6700: Services supplying water for domestic use within buildings and their
curtilages.
BS 6798: Specification for installation of gas fired boilers not exceeding 60 kW
input.
BS 6891: Specification for installation of low pressure gas pipework up to 28 mm
(R1") in domestic premises (2
BS 7593: Treatment of water in domestic hot water central heating systems.
Institute of Gas Engineers Publication IGE/UP/7/1998:
"Guide for gas installations in timber framed housing"
Important: The appliance must be installed and serviced by a competent person
as stated in the Gas Safety (Installation and Use) Regulations 1998. In IE, the
installation must be in accordance with the current edition of I.S,813 "Domestic
Gas Installations", the current Building Regulations and reference should be made
to the current ECI rules for electrical installation.
When tightening or loosening threaded connections always use suitable open-ended
spanners (not pipe wrench, or extensions, etc.). Incorrect use and/or unsuitable
tools can lead to damage (e.g. gas or water leaks)!
We accept no liability for losses caused by technical modifications made
to the control unit or the control system components.
Improper use may cause a risk to life and limb or damage to the appli-
ance or other property.
family gas).
nd
3062555_201804