Installation - Wolf CGB-75 Installation And Operating Instructions Manual

Opening the casing cover
We recommend you remove the casing cover during the

installation.

Release the casing cover with the l.h. and r.h. screw. Release
the bottom of the casing cover and unhook at the top.
After completing servicing, close the front casing
again and fasten the screws tightly. There is a
risk of carbon monoxide poisoning if the flue
system is faulty.
Securing the appliance with the suspension bracket
During installation of the gas condensing boiler,
ensure that all fixings are strong enough to carry
its weight. Also take into account the condition
of the wall, as an escape of gas or water might
result in a risk of explosion and flooding.
Initially, determine the location for the installation of the gas
condensing boiler.
For this, take into account the flue gas connection, lateral
clearances towards walls and the ceiling, and any existing
connections for gas, heating, DHW and electrics.
- Mark the holes to be drilled for the mounting bracket, taking
into consideration the minimum clearances.
- Insert the rawl plugs and fit the mounting bracket with the
coach bolts and washers supplied.
- Hook the gas condensing boiler with the mounting stays into
the mounting bracket.
3062555_201804
8. Installation
Fig.: Undoing screws
Fig.: Drill holes for suspension bracket
Fig.: Mounting brace on the condensing boiler
Screws
Ceiling
Mounting stay
15