Using The Procontrol Ii™ To Aid In Mounting And Removing The Snow Plow; Storage; Wiring Schematics - Sno-Way PROCONTROL II Installation & Owner's Manual

Using the ProControl II™ to Aid in
Mounting and Removing the Snow Plow
The ProControl II™ transmitter can be used near the
snow plow when mounting or removing the plow with the
aid of the power jackstand.
NOTE: For proper procedure in mounting and removal of
the snow plow, refer to your Sno-Way Plow Owner's Man-
ual.
WARNING
When using the ProControl II™ transmitter
near the plow, be especially careful of the
movement of any plow components when any
switch on the transmitter is actuated. Stand
clear of the snow plow at all times to avoid
being struck by any plow parts.
FAILURE TO FOLLOW CAN RESULT IN INJURY
OR DEATH.
Disconnect the cable for the ProControl II™ transmitter at
the harness connection inside the vehicle cab and take
the controller to the front of the vehicle. Disconnect the
plow control harness from the vehicle control harness at
the connector at the front of the vehicle. Connect the
ProControl II™ transmitter to the plow control harness.
The ProControl II™ transmitter can now be used just as it
is normally used in the cab of the vehicle.
When plow mounting or removal is completed, reconnect
the ProControl II™ transmitter to the vehicle harness
connector in the cab. Connect plow harness to truck
harness or place protective caps on truck and plow
harnesses.

Storage

Your receiver module is equipped with male and female
connectors. When power is no longer connected to the
plow, plug the male into the female connector for storage.
Your vehicle harness is also equipped with male and
female connectors. Once the plow is disconnected, plug
the male into the female connector for storage.

Wiring Schematics

ProControl II™ system schematic diagrams are located in
your products Installation & Owner's Manual.
15