Page 1
For use with Halogen Lamps: 99101431, 99101432, 99101433, 99101434 For use with LED Lamps: 96117833, 96117834, 96117835, 96117836 ®, ® ® Sno-Way Down Pressure and EIS are registered trademarks of Sno-Way International, Inc. ™ ™ ™ ™ ™ ™ ™ ™ ProControl...
TABLE OF CONTENTS Page INTRODUCTION ......................2 SAFETY ........................3 INSTALLATION INSTRUCTIONS ................4 Energy Smart System (ESS®) Vehicle Harness Installation ......4 Check Connections ..................6 Receiver Installation on Plow ................6 Harness Installation for Keeping my Halogen Plow Lamps......7 Harness and Lamp installation for Upgrading to LED Plow Lamps ....
COMPLETELY, especially the chapter on SAFETY, before attempting any procedure contained in Sno-Way Service Parts Manuals are available on-line or this manual. at your authorized Sno-Way dealer. Factory contact information is available at www.snoway.com.
Sudden decals are in place and are legible before operation motion of the plow could severely injure a finger. begins. New decals can be obtained from Sno-Way or NEVER stand between the vehicle and blade or directly your local dealer.
CONNECTOR ule (SPIM). If you choose to utilize that system, please see the Sno-Way website for details and kit part num- bers. The instructions for installing the ESS Vehicle Har- ness with an SPIM adapter can be found in the adapter...
Page 6
DIELECTRIC WARNING GREASE Be sure to attach the brown wire to a marker light. A marker light would be a light that turns on when the vehicle light switch is turned to the Park position. FAILURE TO FOLLOW CAN RESULT IN DEATH OR SERIOUS INJURY.
5. Replace the pump harness. Be sure to assemble the harness according to the new schematic decal. 6. Replace the schematic on the inside of the pump cover. 7. Open your ProControl 2 Plus package and pull out MOUNTING the receiver. CHANNELS 8.
HARNESS 1. Pull out the two lamp harnesses that connect the plow lamps to the ProControl 2 Plus Receiver. 2. Attach the shorter of the two harnesses with a yellow wire to the 6 pin connector with a yellow wire coming the plow receiver.
6 pin connector on the driver side lamp. Attach the 6 pin connector with a gray wire coming from the ProControl 2 Plus plow receiver to the 6 pin connector on the passenger side lamp. Then, skip steps 5 - 9.
Headlight Aiming Procedure Table 1: Vertical Beam Aim Guidelines (Line 5) Requirements: Headlamp (Centerline) Nominal Vertical An unobstructed wall that is preferably painted white with Aim Down Mounting Heigh minimum dimensions 10 feet (3 m) wide by 5 feet (1.5 m) high.
Page 11
4. Repeat the same procedure for the right snow plow Visual Headlamp Aiming Procedure: lamp. Use the hot spot beam cross hair target that is developed by Line 5 and Line 4. 1. Activate the snow plow lamp HIGH beams so that they illuminate toward the wall.
Need help?
Do you have a question about the ProControl 2 Plus and is the answer not in the manual?
Questions and answers