Service And Maintenance; Maintenance Safety - Titan 1204 Operation And Parts Manual

9. Service and Maintenance

9.1 Maintenance Safety

WARNING
Failure to comply with the following safety
instructions can and will result in serious injury and
possibly even death.
Wear close fi tting and belted clothing to avoid
getting caught in moving parts. Wear personal
protection equipment (PPE), which may include
hard hat, safety glasses, safety shoes, gloves, etc.
appropriate for the work site and working conditions.
Disconnect Driveline
To prevent injury due to possible unexpected
movement, disconnect the driveline from the
tractor PTO before performing any maintenance
procedure.
Damaged Parts Hazard
Do not use the rotary cutter if any parts are
damaged. If the rotary cutter is believed to
have a defect which could cause it to work
improperly, immediately stop using it and remedy
the problem before continuing.
No Unauthorized Modifi cations
Do not modify the rotary cutter or safety
devices. Do not weld on the unit.
Unauthorized modifi cations may impair its function
and safety and will void the warranty.
If the rotary cutter has been altered in any way from
the original design, the manufacturer does not
accept any liability for injury or warranty.
Crush Hazard
Always set the rotary cutter on safety
stands or
performing maintenance.
Good Working Condition
Keep all parts in good condition and properly
installed. Fix damage immediately. Replace
worn or broken parts.
Replacement Parts
OEM OEM If replacement parts are necessary, genuine
factory replacement parts must be used to
restore the unit to its original specifi cations. Titan
Implement will not accept responsibility for damages
as a result of the use of unapproved parts.
Titan Implement, LLC
(423) 334-0012
Personal
Protection
Equipment
on the ground when
WARNING
Safety Shields and Devices
When completing a maintenance or service
function, make sure all safety shields and
devices are installed before placing the rotary cutter
in service.
The following safety instructions are provided to
help prevent injury or limit equipment damage.
Safety Equipment
A fi re extinguisher and fi rst aid kit
should be readily accessible while
performing maintenance on this equipment.
shop practices. Keep service area clean and dry.
Be sure electrical outlets and tools are properly
grounded. Use adequate light.
Use the Right Tools
Use the correct tools, jacks, hoists, or
other tools that have the capacity for
the job.
Proper Support
Use certifi ed safety stands rated to
support the load when working
beneath the rotary cutter, or performing repairs,
service, or maintenance.
Before working underneath the rotary cutter, place it
on a minimum of four jackstands, with a load rating
of at least 1000 lbs. each.
Do not position the jackstands under wheels, axles,
or wheel supports, as they may rotate and cause the
rotary cutter to fall.
Make sure the jackstands are stable and the rotary
cutter deck is approximately level. Test the stability
of the rotary cutter before working underneath.
If the rotary cutter is attached to the tractor, set
the brakes, remove the key, chock the tractor
wheels, and block the rotary cutter before working
underneath.
Tighten the lower 3-point arm anti-sway mechanism
to prevent side-to-side movement.
41
SAFETY
INSTRUCTIONS
Clean Work Area
Do not leave tools lying around
the work area. Follow good
1200-1600 Series Rotary Cutters
August 2016