Initial Setup Checklist - Titan 1204 Operation And Parts Manual

6.7 Initial Setup Checklist

Effi cient and safe operation of the rotary cutter requires
that every user read and understand the operational
instructions and all related safety instructions outlined
in this manual.
This Initial Setup Checklist is provided for the user/
owner. It is important for both personal safety and to
maintain the mechanical condition of the rotary cutter
that this checklist is followed.
Initial Setup Checklist
(prior to using for the fi rst time)
Location
✔
Titan Implement, LLC
(423) 334-0012
Task
Verify all safety signs are in
place and legible. Refer to
"3.3 Safety Signs" on page
19.
Make sure the rotary cutter
is properly mounted to the
3-point hitch. Refer to "6.3
Attaching to Tractor" on page
33.
Make sure the driveline is
attached to the tractor PTO.
Refer to "5.3 Installation and
Removal of Driveline
to Tractor PTO" on
page 29.
Make sure all hardware
is properly installed and
tightened. Refer to "11.1 Bolt
Torque" on page 53.
Check that the blades are
sharp. Refer to "9.5 Blade
Servicing" on page 42.
Initial Setup Checklist
(prior to using for the fi rst time)
✔ Location
35
Task
Make sure the blade carrier
nut is tight and the cotter pin
is installed. Refer to "9.6
Blade Carrier Removal" on
page 43.
Lubricate all grease zerks and
driveline slip joint. Refer to
"9.2 Greasing" on page 42.
Make sure all safety shields
and guards are properly
installed. Refer to "5.2
Assembly Procedure" on
page 24.
Check the gearbox grease
level. Refer to "9.3 Driveline
Lubrication" on page 42.
Check the tailwheel for
damage. Make sure the
tailwheel support bolts are
tight.
Check the cutting height.
Adjust if needed. Refer to
"6.5.1 Setting the Cutting
Height" on page 34.
1200-1600 Series Rotary Cutters
August 2016