Machine Break-In; Pre-Operation Checklist; Operation Checklist - Titan 1204 Operation And Parts Manual

6.8 Machine Break-In

Although there are no operational restrictions on
the rotary cutter when used for the fi rst time, it is
recommended that the following mechanical items be
checked:
1. After 1/2 hour of operation:
a. Tighten all fasteners if necessary.
b. Lubricate all grease fi ttings.
2. After 10 hours of operation:
a. Go to the normal servicing and maintenance
schedule, as defi ned in the Maintenance
Section.
1200-1600 Series Rotary Cutters
August 2016

6.9 Pre-Operation Checklist

Before each use of the rotary cutter, the following areas
should be checked.
Checklist Before Each Use
✔
Make sure the rotary cutter is positively attached to
the tractor 3-point hitch.
Use only an appropriately sized tractor to pull the
rotary cutter. Refer to "6.2 Tractor Requirements" on
page 31.
Make sure the driveline is attached to the tractor PTO.
Make sure all safety shields and guards are properly
installed.
Check the blade bolts and blade pan nut.
Check the condition of the blades.
Check the cutting height. Adjust if needed.
Inspect the overall rotary cutter for potential problems
or damage. Do not use the rotary cutter if it needs
repairs of any type.
Grease the driveline U-joints and slip joint.

6.10 Operation Checklist

Although the rotary cutter is easy to use, each operator
should review this section to familiarize themselves
with the detailed safety and operating procedures.
When using this machine, follow this procedure:
1. Clear the area of bystanders, especially small
children.
2. Clear the area to be cut of stones, branches, debris,
and any hard objects that may be thrown.
3. Mark the location of objects that cannot be removed.
4. Review and follow the Pre-Operation Checklist.
5. Engage the PTO at low engine RPM, then raise
PTO speed to 540 RPM.
6. Begin cutting at a slow speed, then increase to a
speed that gives a clean cut without lugging the
engine. Do not operate above 5 MPH.
7. Never allow blades to contact solid objects like
rocks, posts, wire, curbs, guardrails, or the ground
while mowing.
8. Avoid operating the rotary cutter in reverse direction
when possible. Check to make sure there are no
persons behind the rotary cutter, and use extreme
care when maneuvering in reverse.
36
Task
Titan Implement, LLC
(423) 334-0012