Table of Contents
Advertisement
6.
Clean blade with mineral spirits, then apply
thin coat of quality metal protectant before
re-installing blade.
7.
Reverse Steps 1–5 to re-install blade.
To remove/re-install lower blade:
1.
Loosen cap screws securing support rods to
rear work stop assembly. Remove assembly.
2.
Remove (2) outer cap screws from lower
cover, and cap screws (3 on G0828; 5 on
G0829) from upper cover (see Figure 36).
Remove
Screws
Figure 36. Remove rear lower cover cap screws
to access lower blade (G0828 shown).
-26-
Cap
3.
Loosen cap screws securing lower blade to
frame (see Figure 37). G0828 uses 7 cap
screws; G0829 uses 11 cap screws.
Lower Blade
Figure 37. Lower blade removal (viewed from
bottom).
4.
Have another person wearing heavy leather
work gloves support blade and remove it.
5.
Clean blade with mineral spirits, then apply
thin coat of quality metal protectant before
re-installing blade.
6.
Reverse Steps 1–3 to re-install blade.
7.
Check and adjust blade gap, following proce-
dures on Page 24.
Model G0828/G0829 (Mfd. Since 02/17)
Advertisement
Table of Contents
