Installation - Lincoln Electric Infinity-Pak K3926-1 Operator's Manual

INFINITY-PAK STATION

INSTALLATION

2.0 ASSEMBLY INSTRUCTIONS
A.
C.
B.
1. Parts as shown:
A. Base
B. Front Leg
(adjustable length)
C. Wire Bridge
D. Center Post
E. Wire Guide Module
Transfer Arm
F. Conduit Bridge
Some models may feature
additional Guide Modules
on top of transfer arm.
2. Use the four nuts and bolts
to attach the front leg (B) to
the base (A). If the unit is
for use with four boxes or
drums, install the back leg
on the opposite side. Note:
This may already be assembled upon shipment of some units.
3. Attach the Wire Guide Module Arm Assembly (E) to the top of the
center post (D). Once the post on the base is inserted into the post
on the arm assembly, firmly tighten the nut to secure. Note: This
may already be assembled upon shipment of some units. The arm
assembly is shipped pre-adjusted for 24" (610mm) square box
packaging. Do not tighten the conduit into the connectors on the
Guide Modules until properly adjusted.
4. Attach the Wire Bridge (C) to the front leg using the two nuts &
bolts provided. This will be adjusted later in step 7 after the wire
packages are installed.
A-1
INSTALLATION
F.
E.
D.