Table of Contents
Advertisement
6 Reference and Specification
Comms range setup is used to re-align the SCPI index (x) to the correct pressure range.
Where Range is index (1)......etc.
8.
Press the top touch area on the screen to change the range value.
9.
Use the Up and down arrow to highlight the new Range value.
10.
Press the top Measure on the screen to change the range value. The new range value
is set and the screen returns to the COMMS RANGE SETUP screen.
11.
If necessary, repeat Steps 7 to 10 to set up other range values.
12.
Press the Escape icon to go back to the COMMS RANGE SET UP screen.
13.
When complete, press the Escape icon as necessary to return to the Measure screen.
IEEE
Located on the rear panel an external IEEE 488 connection requires:
Connector
Communications
Default Address
Protocols
Heritage emulation
Ethernet
Located on the rear panel an external Ethernet connection requires the following:
Connector
Protocol
Terminator
Default Address
Host name
Web Password
Access control
Reset LAN Settings Selected in Supervisor set-up menu
Ethernet Firewall
A firewall protects the Ethernet connection. The firewall is always turned on. The following
ports are unfiltered to allow remote communication and control.
Port
80/tcp
111/tcp
111/udp
443/tcp
K0470 Revision A
24-way 'D' female wired as IEEE 488 standard
IEEE488 GPIB
16
PACE SCPI
DPI 142/150, DPI 141
Ethernet RJ45
SCPI
CR/LF
Auto IP (0.0.0.0)
PACExxxxxx (where xxxxxx = serial number)
0268
Open
Description
http (Web server)
rpcbind (RPC for VXI)
rpcbind (RPC for VXI)
https (Web server)
6 - 14
[EN] English
Advertisement
Table of Contents
